Flat roofs · 4 min read

Flat roofs in New Mexico: new TPO membrane or a silicone coating?

Pueblo-style and flat roofs fail at drainage, parapets and seams. When a silicone restoration coating is the smart move, when it's throwing money away, and what a proper TPO replacement includes.

Flat and low-slope roofs are everywhere in New Mexico — pueblo revival, territorial, adobe, and the flat sections over garages and additions on otherwise pitched homes. They are not harder to keep dry than pitched roofs; they are just less forgiving of three things: drainage, parapets and seams. Decide those well and a flat roof lasts decades.

Why flat roofs leak here

Ponding water. A roof that holds puddles 48 hours after a monsoon storm is slowly cooking its own membrane. UV and heat degrade the roof under the puddle, dirt collects, and the low spot gets lower as the insulation compresses. Ponding is a drainage problem first and a roofing problem second.

Scuppers, canales and drains. On a parapet roof, the only way off is through the scuppers (openings in the parapet), canales (the wooden or metal spouts), or interior drains. A scupper that is undersized, clogged, or set a half-inch too high creates a pond behind it.

The parapet joint. Where the roof membrane turns up the inside of the parapet wall and meets the stucco is where most leaks start. The membrane has to go up and over the top of the parapet (or terminate under a proper cap) and the stucco has to be sound. Caulk at that joint is a six-month fix.

Seams and penetrations. Every seam, vent, swamp cooler stand and skylight curb is a place for water to get in. Glued seams fail; heat-welded TPO seams are stronger than the sheet.

When a silicone coating makes sense

A silicone restoration coating is a fluid-applied layer that goes over the existing roof, seals seams and small cracks, and gives you a new reflective, UV-stable surface. Silicone, unlike acrylic, tolerates ponding water, which is why it’s the right coating for most of our flat roofs.

A coating is the smart choice when:

  • The existing membrane or built-up roof is still attached, dry and intact — no soft spots, no wet insulation.
  • The leaks are at seams, flashing and small cracks, not from a saturated roof.
  • Drainage problems are minor and can be fixed first (clear scuppers, add a cricket).
  • You want 10–15 more years before a full replacement, at a fraction of the cost.

A coating is the wrong choice when the roof is holding water inside it. Coating over wet insulation traps the moisture, the blisters come through within a season, and you’ve paid for a very expensive paint job on top of a roof that still needs replacing. This is why a moisture check — probing or an infrared scan, plus walking the roof for soft spots — comes before any coating quote. If someone offers to coat your roof without walking it, that’s a sales call, not an inspection.

What a proper TPO replacement includes

When the roof has reached the end, a new single-ply membrane is the replacement. Here’s what should be in the scope — and what a cheap quote leaves out:

  1. Tear-off to the deck, so wet insulation and rotten decking are found and replaced, not buried.
  2. Drainage design: tapered insulation that pitches water toward the scuppers, and crickets (small ridges) behind rooftop units and on the high side of skylights so water goes around them, not into a pond.
  3. New scuppers and drains, sized and set at the right height, with overflow scuppers where a primary drain could clog.
  4. 60-mil TPO membrane, mechanically attached or fully adhered, with heat-welded seams.
  5. Parapet tie-in: membrane carried up the parapet and terminated with a metal cap or under a counterflashing — and any failed stucco on the parapet repaired, because the roof depends on it.
  6. Flashed penetrations with prefabricated boots and curbs, not just more sealant.

Repairs to a parapet or a canale are often a roof repair job rather than a replacement; a full membrane with drainage work is a flat roof replacement. Either way, start with the free inspection — the photos tell you which one you need.

See your own roof measured. Type your address — explore an aerial roof measurement and request a free inspection. Your written price follows the inspection.
Start my roof plan
FAQ

Questions about this topic

How do I know if my flat roof is ponding?

Water that is still standing 48 hours after rain is ponding. Look for rings of dirt or algae stains, blistered coating, and areas that stay darker than the rest of the roof.

Is a coating a repair or a replacement for insurance purposes?

It is generally treated as a repair or maintenance. If the roof has storm damage, document it before any coating goes on, because coating covers the evidence.

What is TPO?

Thermoplastic polyolefin — a white, single-ply membrane whose seams are heat-welded rather than glued. It reflects heat, resists UV and is the most common flat-roof membrane on homes and commercial buildings in the Southwest.

Can you put TPO over my existing roof?

Sometimes, if the existing roof is dry, well attached and there is only one layer. Usually it is better to remove the old roof so wet insulation and bad decking can be found and replaced.