Maintenance · 3 min read

Roof ventilation in Albuquerque: why attic heat ruins shingles

How attic ventilation works, the signs your attic is cooking your roof from below, and what gets fixed during a roof replacement.

On a summer afternoon in Albuquerque a dark shingle roof can be well over 150 degrees on top. If the attic underneath cannot get rid of its heat, the shingles are baked from below as well. That is one of the main reasons shingle roofs here fall short of their rated life.

How ventilation works

Hot air rises. A vented attic lets cooler outside air in low, at the eaves or soffits, and lets hot air out high, at or near the ridge. The air moving between those two points carries heat and moisture out.

Both halves are needed. A ridge vent with blocked soffits has nothing to pull from. Plenty of soffit vents with no exhaust have nowhere to send the air.

Signs of a ventilation problem

  • Shingles that are curling, blistering or brittle well before their age suggests
  • An upstairs or attic that is much hotter than the rest of the house
  • Insulation blown over the soffit vents
  • Rusted nail tips or dark staining on the underside of the roof deck
  • In winter in the East Mountains, ice building up at the eaves

What we check on a re-roof

When the old roof is off, we can see the deck and the vent openings. Typical fixes are cutting in a continuous ridge vent, adding or opening intake, removing mismatched old vents and closing the holes, and installing baffles so insulation stays out of the airflow path.

Flat roofs are different

Most flat roofs in New Mexico have no vented attic at all. The insulation sits directly under or over the deck. On those roofs a reflective white membrane or coating does the job ventilation does on a pitched roof: it keeps the heat out in the first place.

Vent types, and which ones work here

Ridge vents run along the peak and let hot air out along its whole length. They are low-profile and, paired with good intake, are the most even exhaust there is.

Box vents are the square hoods near the ridge on many older Albuquerque roofs. They work, but it takes several to equal one ridge vent, and each is another opening to flash.

Turbines spin in the wind and pull air out. They move a lot of air on a breezy day and can squeak or seize as they age.

Powered fans can pull conditioned air out of the house through ceiling leaks if the attic is short on intake, which raises the cooling bill they were meant to lower.

Intake is where many New Mexico homes come up short. Houses with little or no roof overhang have no soffit to vent. On those, an edge vent installed at the eave during a re-roof brings air in under the first courses of shingles.

One more check: bathroom and kitchen exhaust fans should duct to the outside, not dump into the attic. Moist air released under the deck in winter is a common cause of dark, stained sheathing.

Why it matters for your warranty

Shingle manufacturers require adequate ventilation, and poor ventilation can be grounds to deny a material warranty claim. Getting it right protects the roof and the paperwork.

If your shingles are aging faster than they should, a free inspection includes a look at the vents. See also how long roofs last in New Mexico.

See your own roof measured. Type your address — explore an aerial roof measurement and request a free inspection. Your written price follows the inspection.
Start my roof plan
FAQ

Questions about this topic

How much attic ventilation does a house need?

The common building-code rule is 1 square foot of net free vent area for every 150 square feet of attic floor, split between intake and exhaust. Some balanced designs are allowed at 1 to 300.

Can I mix a ridge vent with box vents or a powered fan?

It is usually a bad idea. Different exhaust types can pull air from each other instead of from the eaves, which short-circuits the airflow.